COUSSINETS SKF PDF

Comme pour les coussinets et les bandes composites, SKF fabrique de série des rondelles de butée composites à partir de matériaux composites PTFE et POM. For additional information about the meaning and limitations of the product data, refer to SH bushings. Imprimer cette page; Partager. d, 35, mm. D, 60, mm. D1, 68, mm. L, 37, mm. L1, 49, mm. B, , mm. Calculation data. Max. torque, Mv, , N·m. Max. axial load, Pa, 41, kN. Mounting.

Author: Dir Mezisida
Country: Mongolia
Language: English (Spanish)
Genre: Life
Published (Last): 28 August 2008
Pages: 296
PDF File Size: 8.31 Mb
ePub File Size: 17.6 Mb
ISBN: 291-1-99167-794-5
Downloads: 72134
Price: Free* [*Free Regsitration Required]
Uploader: Vikinos

SKF sintered bronze bushings are impregnated with a lubricant and.

Joints à frottement mécanique, coussinets SH

Sufficient cooling fluid should be applied as well to avoid excessive temperatures, as they can destroy the bushing. Check also the shaft for sharp edges, burrs or surface defects, which could damage the sliding surface of the bushings.

Care should always be taken when mounting FW bushings not to damage the sliding layer or side faces. When mounting, thrust washers should be positioned so that the steel backing abuts the housing wall.

  ALARME POSITRON MOTO MANUAL PDF

Joints à frottement mécanique, coussinets SH – SHT 70

In addition, cleanliness, and understanding the causes of premature bearing failure can help too. Mounting Skill and care in mounting are prerequisites for long couussinets service life.

If composite plain bearings, for example strips, are to be located in a housing using an adhesive, the adhesive should be suitable for the expected operating temperature and should have suitable expansion, aging resistance, strength and curing properties.

Check that the counter surface shaft seat and other components such as the housing are clean, deburred and that they do not contain any abrasive particles.

Otherwise when the bushing comes in contact with absorbent material it may wick the oil away very quickly. The position of the lubrication groove of solid bronze bushings depends on whether it is an oscillating or rotating or movement and, for the latter, whether oil or grease lubrication is applied fig.

SKF also recommends, particularly for larger bushings where more force is required that they be cooled before mounting. For larger bushings, SKF recommends using a mounting ring fig. To facilitate mounting FW busings, the bushing may be split lengthwise into two halves by using a diamond coated grinding wheel.

  KOSTANA BORISAV STANKOVIC PDF

skt

Then drive the bushing into place with a mechanical or hydraulic press or by tapping the dolly lightly with a hammer. If no operational experience is available, SKF recommends contacting an adhesive manufacturer for advice.

Modèles et variantes

Imprimer cette page Partager Partager cette page. When applying an adhesive, care should be taken so that no adhesive reaches the sliding surface. To do this, place an O-ring on the dolly to keep the bushing in coussijets.

To install bushings, with or without a flange, SKF recommends using a mounting dolly particularly for composite fig. To s,f the mounting of small bushings, apply a light coating of oil or grease to the housing bore. Once all the components have been cleaned and checked, the bushing is ready to be installed.