INTEL 8255 DATASHEET PDF

DATASHEET. The Intersil 82C55A is a high performance CMOS version of the industry standard A and is manufactured using a. The Intel (or i) Programmable Peripheral Interface (PPI) chip was developed and .. , Complete Description about the Intel IC; , Datasheet; , functions overview; The Intel (or i) Programmable Peripheral Interface (PPI) chip .. “PCI A Datasheet” (). 6.

Author: Yokree Kagakus
Country: Pacific Islands
Language: English (Spanish)
Genre: Marketing
Published (Last): 1 July 2017
Pages: 435
PDF File Size: 12.82 Mb
ePub File Size: 11.96 Mb
ISBN: 987-4-58749-883-6
Downloads: 70706
Price: Free* [*Free Regsitration Required]
Uploader: Kikasa

The Intel or i programmable peripheral interface PPI chip was developed and manufactured by Intel in the first half of the s for the Intel microprocessor and is a member of the MCS Family of chips. The i was also used with the Intel and Intel [1] and their descendants and found wide applicability in digital processing systems. Intfl was later cloned by other manufacturers.

A Datasheet(PDF) – Intel Corporation

The is also directly compatible with the Zas well as many Intel processors. Address lines A 1 and A 0 dataheet to access a data register for each port or a control register, as listed below:. The control signal chip select CS pin 6 is used to enable the chip. It is an active-low signal, i. As an example, consider an input device connected to at port A.

  HELMUT SCHOECK PDF

If from the previous operation, port A is initialized as an output port and if is not reset before using the current configuration, then there is a possibility of damage of either the input device connected or or both, since both and the device connected will be sending out data.

The two modes are selected on the basis of the value present at the Ihtel 7 bit of the control word register.

As an example, if it is needed that Dataheet 5 be set, then in the control word. This mode is selected when D 7 bit of the Control Word Register is 1.

For example, if port B and upper port C have to be 82255 as input ports and lower port C and port A as output ports all in mode The two halves of port C can be either used together as an additional 8-bit port, or they can be used as individual 4-bit ports. Since the two halves of port C are independent, they may be used such that one-half is initialized as an input port while datasneet other half is initialized as an output port.

When we wish to use port A or port B for handshake strobed input or output operation, we initialise that port in mode 1 port A and port B can be initilalised to operate in different modes, i. Some of the pins of port C function as handshake lines.

  LUDMER LAS TRETAS DEL DEBIL PDF

For port B in this mode irrespective of whether is acting as dahasheet input port or output portPC0, PC1 and PC2 pins function as handshake lines.

Programmable Peripheral Interface – Intel Chipset Datasheet

Only port A can be initialized in this mode. Port A can be used for bidirectional handshake data transfer.

This means that data can be input or output on the same eight lines PA0 – PA7. In this mode, the may be used to extend the system bus to a slave microprocessor or to transfer data bytes to and from a floppy disk controller.

Intel 8255

Acknowledgement and handshaking signals are provided to maintain proper data flow and synchronisation between the data transmitter and receiver. Intel Intel D Interrupt logic is supported.

Input and Output data are latched. Microprocessor And Its Applications.

Retrieved 3 June